the RSX chassis
 

hey, well i manage to rebuild an RSX for the first time but i don't know if i did it right, well anyways this is what I thought that I did wrong, well while intalling the motor I had put the back yellow thing that hold the wires and the motor normal. then I stuck the driveshaft into the gear and put the back into the chassis, well I remembered some post about the screws on the bottom and how the middle hole is for the RSX. it hit me that the back was longer then it was suppose to, so I reversed the yellow thing that hold the wires and secures the motor. after that it snugged perfectly. well I don't know if what I did was right so can anyone help me out? this is my first time working on an RSX. -salamat :D ;)



P.S. The yellow thing isn't the front motor mount that looked like a wannabe heatsink ;)

Sounds like you did it right.
Happened to me but with my supra, and the back end wouldnt fit to the holes. I noticed that i put in the rear motor mount the wrong way :p

took me a month tro figure that out....:o

:eek: :eek: :eek: that means i've been installing all mine and the other ones wrong.......

no. you are right on the others. i think the rsx in the only one that you have to reverse the front motor mount. I don't have a skyline, but I am sure that is the same as the civic and supra.

....wooo I feel releaved! thanks shiporu!

the front motor mount should be facing forwards. the flat piece should be closer to the front than that back. i wonder how they're gonna make it any shorter?