TinyRC.com

TinyRC.com (http://tinyrc.com/forums/index.php)
-   Combat Digi Q (http://tinyrc.com/forums/forumdisplay.php?f=77)
-   -   Charge combat digiq with a DC power supply.(without 4 AA batteries) (http://tinyrc.com/forums/showthread.php?t=18106)

vantzeng 02-08-2004 01:14 AM

Charge combat digiq with a DC power supply.(without 4 AA batteries)
 
Tools needed:
Electronic knowledge.
DC Power supply with 6 Volt output.

step0:
+- +- +- +-
(BATTERIES=1.5Vx4)
->
+ -
(DC power supply=6V)

step1:
Open the R/C control's battery case.

step2:
You could see a text "LOCK"
when you open/close your battery case.

step3:
Look deeply into where
you put batteries in the R/C control.
You could see there
are four battery slot.
So I define the battery slot which
closest to the text
is the upper right battery -.

setp4:
The lower left battery -
and lower right +
was connected to each other.
(look carefully you could see
there are a wire which was
connected to each other)

step5:
Connect the power supply +
to the upper left battery +,
Connect the power supply -
to the upper right battery -.

step6:
Switch R/C control to the charge position.

step7:
Turn on the R/C control.

step8:
You could see the R/C control is in the charge status.

Combat-Digi-Q 02-08-2004 01:51 PM

Good work, Although all of that would not be necessary if you payed for the 4 bay charger, with that you can charge all 4 tanks at once. The 4 bay charger practiclly pays for itself when you charge many tanks at once. If you only had 1 tank then your idea is good

vantzeng 02-08-2004 06:56 PM

In taiwan,the store don't sell the 4 bay charger.
I want buy one too.
They only sell combat digiq.

4-D 02-08-2004 09:27 PM

i almoust did that to but thout it best 2 just get a 4 bay charger.
its so much more convenient.but if your still trying 2 save money
then might i suggest makeing a hole on the bottom of the controler and mounting some kind of plug.so that way u dont have a anoing wire hanging out all the time.

o ya and if im right i dont think u would wont 2 have the batteries
in at the same time your 6volt 400mAh transformers pluged
caz your 400mAh will double up as 800mAh and fry your controler and mabey your tank

Combat-Digi-Q 02-09-2004 07:24 AM

It would fry the delicate circuitry in the controller but would not affect the tank at all, the controller isnt supplying power to the tank through the air:rolleyes: The tank would be fine but you would be out a controller!


All times are GMT -5. The time now is 05:37 AM.

Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.