Winding question
 

When decreasing winds on a motor, do unwind the entire thing then rewind it to your preference?

geo, you live in pa, right? well, theres going to be a race soon in harrisburg, do a search on the forums to find it...

Already tried that.

did you find it? if not its here

I was talking about the winding stuff.

I is feelink stupidey now

Haha been there:)

You don't unwind the entire thing...


If you want to cut the wires off the comms, you can. Just unwind them however many turns you need, then solder them back at the comms they came from. Be sure to take off the same amount of winds from each leg...

If you unwind it, then you can rewind it tighter and you should get a performance increase.

That is all I do on a wind reduction... I'm lazy. :p

Actually, I think I've been going that route after taking that very same advice from you - lol

Your laziness is contagious! :D

Oh geez. . .I definetly need a tutorial on this.

You need a tutorial to show you how to snip a wire, unwind it a few turns, and solder it back where it came from to begin with?...

Yeah. . .:(

You probably need to hold off on this mod...