mini-z's and tamiya motors will they work
 

hey guys I'm new and I was wondering if any mini-z motors will work or if they are too powerful . will they fry any thing? and the tamiya motors I heard about theese in one of the posts and i was wondering if they work good or not. I want all the info i can get

thanks

I'm using a xspeed w/ a 8 tooth pinion
and AWD

it flies!!!!!

thanks
 

thanks man i think i'm going to try the x-speed I just need a pinion puller from hobbytown

i was thinking of one of those too
but whats a pinion puller

A pinion puller is a tool that pulls the pinion or the little gear off the end of the motor so you could put a differant pinion on the end of your motor, so you could put the 11 tooth pinion on for top speed


http://www.professormotor.com/toolcatalog.shtml

check out the pinion puller on this site

ooh thanx

I have the PN Racing Speedy Modified motor, but wont have a pinion puller untill Friday. But it fits perfectly in my Stage 2 heatsinc...

I just bought an x speed motor. I installed it into my skyline and it began to smoke. I unplugged the motor and plugged it back in. After I plugged it back in the car worked fine but my range was only about 6 feet. So I tried putting the old stage 2 motor back in and still short range. So I guess I am going to need to buy a new xmod and try the x speed motor in it.

check this out..

http://www.fantasyworldhobbies.com/

ninco press/puller nice for the dollar..
Ninco Pinion Press and Puller (Item # NIN80201)