Trouble with 27ZZ and SE.
 

Me and a friend were racing at work, he was using the SE and I was using my new 27ZZ. When he turned his SE on my 27 quit running. We went through all of the sub-freq's too and it done the same thing. When he would turn the SE off mine would work and as soon as he would turn it on mine would stop. Any reason why or a fix, let me know?

I noticed that as well. Don't forget the SE's are 27mHz as well.

Really? That didnt happen to me. I drove around my 27mhz SE with a regular zip zap, and nothing happened. Hmmm.

Not sure if this is related, but I think they revert to channel 1 if you turn em off. But Im sure u know that.

I under stand that they go back to channel 1 after being turned off, it just blows my mind that they interfer with each other. I could undrstand if you could control the reg zip with the se controller, but you can't.

It's not too hard to understand really, assuming the SE uses 27mhz to run, the subchannels just mean that they chop that band into smaller chunks, say 27.015, 27.025 etc. and each SE sends they signals within that band depending on the channel you set them to,
The regular ZZ uses most of the 27 band so there will be interference where the two coincide.

pure guessing here..

i got the same problem. what wild03 said sounds about right. different version PCBs on the ZZs might make a difference too.

Your pure guess sounds very good to me wild03.