How to lower?
 

How do i lower a Shen Evo? I guess it's the same as MS and BC-G bodies, but how do i do it? I know i can use springs form pens, but i cant see how they were going to help as a spring would lift it?:confused:
please help.. I really wanna do it!

Go to www.rcmod.com. They have a way to lower it without using springs.

cut the front mounting tab and make a new one and glue it under neath works for the front only

i would think that if you are planning on lowering the back also you would have to cut a new slot in the body, because you cant move the tab lower in the back without modding the heat sink. its possible to do.

Well, thanks.. And yes, i only thought of lowering the front as i cant translate some of the mods.. Lowering the back for one.
BTW also thanks for the link! It's a nice site...!

to lower the back all you have to do is fill the hole with some epoxy so that its basically sealed, then cut a new hole above it and there you go!

What hole? The one which the gear fit into? Like i said im not familar with English as you are..:(

Ahh.. i think i understand! But if it's what i think it is then you cant change the gears?

He's talking about the hole in the back of the car body.

thanks for clearing that up Jtskty. If you still dont understand, its the little hole in the back of the actual car body where the tab fits into, fill that up then cut another hole of equal size above it.

Car body:

Side Rear wheel(R)
_______________________
|_______
| | |_
PCB | | |_|<--This tab?
____*__|
______________________|

Rear wheel(L)

Sry.. dont have a cam..

sh*t..
I tried in paint..

Thats the one. just fill the hole that goes into then make another it works on the front too

Dont cut the tab on the chassis. Fill in the hole that those tabs go into, then cut another hole higher up on the body