twin motors
 

about installing those twin motoes...... i dont understand step number 7 [url]http://www.tinyrc.com/forums/showthread.php?s=&threadid=10069&perpage=15&pagenu mber=1[url] it says to add a piece of metal to jumper the second motor? where do u put the metal? on the back of the motor? and what kind of metal works best? thx.

Beats me but my late 2 motor ms I just soldered both moters together and it increased torque since there where both 2.2s

I haven't done it yet, but I think you should solder small wire from one motor's contact to the other. This is the best mod ever!

Earlier today, I was bored, and I decided to 'attempt' the dual motor mod. I did it cheaply with pieces of metal and tape. It worked, but the gears were really tight packed together.

I tried a duel motor mod too so I could use the MPH/KPH axle from a kit racer
and it didnt work can someone give me good step by step instructions mine ended up going slower with duel motors then with one
is it ok to use a kit 2.6 and a ms 2.6

Make sure all the gears mesh perfectly. I just did a dual motor mod, and it's even more quiet than it was before! Then you should have no problems.

I recommend hard-wiring the motors also. Just from experience (especially with my 3.0), any other sort of contact isn't good enough.

Lord_Nick_D --

Here is the instructions, good luck!

I was the one who asked in the first place! I just ordered 2 3.5s from Bit Mod 1, and 1 doesn't Work! You have to put the jumper metal on the back of the motors. Oh, And the 3.5 that does work has tons of torque and speed!

The motor doesn't work at all? Or just in the dual motor?

The NSX won't as much as a hack job as this (done with a swiss army knife), and I think a bug would probably need no mod to fit it, and the same with buses.

The motor needs a push from reverse to forward, and Ithink they either gave me a 3.8 and a 3.5, or a 3.2 and a 3.5, because the junk motor revs higher than the working one (I can hear it), but has less torque than the other one, so I think it's a 3.5. The only thing that confuses me is that they are both pink-ended. I thought those were only for 3.8s? Oh, and how do you like the black rears, and the chrome fronts? I think it looks old-school, because old dragsters had cool wheels on the front, and bad wheels on the back. And I have never used the 1.0 it came with!

viperdout: ha ha that's like my desk!

Mines worse than that! It has little pieces of cars all over my dresser, along with some other stuff.... :p

what d'ya think of my hack job on my benz body? And How does the NSX body look to you?

Bleh, the benz body is a total hack job! Lol, I did one with a knife, and it looks fine. The NSX body looks good too.