Thanks for the nice comments!!
I would say your set-up is pretty good as-is with the 33/6 and if you notice the trails are too hard to traverse you can then try the swap. If you have a SSMT you have the board already!

I posted a little vid of the Hummer at the link below. I'll try to make a better one soon!

http://video.google.com/videoplay?do...977&pr=goog-sl

are you talking about a ssmt 1:24 or the "oh so famous" 1/43 ssmt??? which by the way i am dying to get.......
i am asking you this because i have an ssmt 1/24, and i want to swap the electronics for a new iwaver PCB, so it could be proportional.
annyways, sweet hummer, and keep the modifications coming, i like your ideas. i have been thinking of a tie rod design to eliminate the bump steer, but i will use one steering rob for each knuckle.

-Lino

On your steering mod diagram, there is three screws...one in tie rod...one in lower a-arm into bottom of hub...and don't know where the other goes. Connect custom plastic piece to modded tie rod and where do you connect custom piece on the hub???

###############

Nevermind figured it out.........sorry
Keep forgetting that tie rod in modded

Yeah, I like to nkow the details too. its too bad the swampers are hard plastic, guess u must spin out on TILE FLOORS :)

Eric

Well does it, Im new the EVO Trucks, and just got a TITAN but the wheel slop is nasty...I want to get bearings but dont know if that will fix the sloppiness in the 4 wheels.


Any got time to elaborate ways of cure this EVO-truck disease..of mine?

ERICbbskyw

You want "wide track bearings"

I haven't ordered from this guy yet, but he has good dealings with a lot of folk at Scale4x4Rc..... and they say he is fast to ship also, even though it's overseas.
Click me.