HAS ANY ONE USED THE FRONT KNUCKLES AND REAR AXLE OF A BIT 2 HAVE A FULL SIZE WHELL MOD. AND ALSO I READ HOW DO DO SPINERS ON ZZ RIMS BECAUSE THE ARE HUBCAPS

the panther is the same chassie as the bit and the bodys fit fine

45k motor
 

does anyone know if this motor really works in a zz? the guy says it was tested but i was wondering if any of u tried it. :confused:
http://cgi.ebay.com/ws/eBayISAPI.dll...tem=3168071304

Car-100 compatibility list
 

If anyone needs to know about Car-100 compatibility here goes.
Compatibility was tested with components from bitcharg, shen qi wei and a variety of clones.

Motors: YES.
Took all test engines with a slight mod: one of the terminals in the engine bay needed prizing in a little, since the Car-100 motor has extra length from a huge base terminal. Once this was done, the engine bay was fully compatible with all test engines

Suspension: YES, but the mounting holes on the car-100 needed drilling out slightly. Once done, Car-100 could use all test suspension bars.

Rear axels, front wheels, tyres: YES

Gears, steering components: YES.

Batteries: NO. The Car-100 SUCKS power, it uses a 160mAh batt. I haven't actually tried the 50 or 80mAh hour batteries in the Car-100 yet. I expect they might not even power the board, and if they do work will have woeful running time.

Heat Sink: NO.

Shell: Not a hope in hell (Car-100 chasis too long).


Picture shows 4.2 clone engine in Car-100 engine bay. Note angle of terminal - it has been bent forward since the clone motor is too short.