new front axle for my next truck

size comparison

front drive/steering axle

another shot

ESC with upgrade ;)

:D close up

side view of the truck

killer-
stunning work:D really amazed.

could you post the pictures of you sc upgrade here as well?

:ö: thanks Arch!, yup i did posted pictures of the ESC, there you'll see i'm just using 2 resistors, i replaced the old SMD(?) resistors (those tiny black resistors as small as this o ) because i am quite skeptic on the way they perform so i replace it with a small (regular) size resistor.

notice that i'm just using 2 resitors instead of 3?.. those two are 2.2 k Ohm and 5.4k Ohm resistor... i used one 5.4k ohm resistor to replace what is supposed to be 2 x 2.2k ohm resistor, like instructed on the website i posted... hope this helps ;)

-æ

articulating arm
 

killer thanx a bunch for the help with the front steering arm.

Yeah this is my first 1/87 truck.

i race 1/10 nitro and have played with the bit charg but this sounds like so much fun.

so you think its posible to use a rx that is for a 1/10 car in these trucks?

thanx again.

Re: articulating arm
 

:ö: no problem ;) , if this is your first 1/87 rc truck i suggest you start with a 4 x 2 1/87 roco MAN 5ton truck, about the rx?, nope!, you cannot use the standard size 1/10 rx on a 1/87 scale truck, notice the yellow thing on my truck electronics? that is a 1/10 rc car standard size FM crystal, though you can use a 1/10 rx but you have to look for the smallest one about the same size as the rc plane rx, or you may use a trailer for the truck so you hide your 1/10 rx there.. fun?, yeah! and addictive too! :p -æ

Great job Killer!!

I see you have a better camera now too!!:D

-Todd

rx and servos
 

killer

exactly what brand and type of servos and rx should i purchase for these trucks?

again thanx for all the help.

CVICTIM-
this has all been coverd. please search or read through some of the entire posts, as this section of the forum is rather new, there aren't that many and shouldn't be difficult;)

4x4
 

my new 1/87 4x4 chassis.